Modular rubber cable ramp – 2 pieces, drive-over 100 x 15 x 3.1 cm

Modular rubber cable ramp — pack of 2, load-bearing up to 8–16 t>

Professional solution for protect cables and pipes on pedestrian and vehicular paths. Each module, in high density rubber/strong> with yellow non-slip lid, organizes and secures the passages in construction sites, events, warehouses, workshops, logistics areas and parking. The modular design with male/female joints allows you to create lines of the desired length. Sale in pack of 2 modules (not A4 size).

Key Benefits

• Driveability/strong>: reinforced structure with axle load capacity up to 8–16 tonsstrong> (indicative value, depends on the ground, load distribution and correct installation).
• High security: lid to yellow/black contrast, non-slip surface, bevelled anti-trip profile.
• Multi-channel protection: multiple internal compartments to separate and protect power cables, signal cables or low pressure pipes./li>
• Modular: quickly connects to other modules via interlocking joints male/female to cover long stretches.
• Robust toheavy usestrong>: Resists impacts, compression, water, dirt, oils and light vehicle traffic.
• Inside/outside: suitable for exhibition halls, loading areas, construction site routes, events and car parks.

Typical applications

• Events and fairs: cable passages for stage, audio, lighting, video and power.
• Construction sites and workshops: protection of temporary power lines and low pressure pipes.
• Warehouses and logistics: safe crossings in areas where pallet trucks/forklifts transit.
• Retail and offices: orderly passages without obstacles in areas open to the public.

Installation

1. Prepare the base: install on a flat, clean, and dry surface; avoid slopes and depressions.
2. Open the lid And houses the cables into the channels without crushing them; close until they click.
3. Connect the modules using the male/female joints for the desired length.
4. Report: In high traffic areas, use cones/tape or road markings as required by local regulations.

Synthetic specifications

Notes and safety

• Crossing speed : maintain low speeds (< 10 km/h) on driveways with cable ramps.
• Correct installation : avoid sharp curves, suspended edges, and uneven surfaces; align the modules well.
• Compatibility : Use intact cables; check the diameter suitable for the channels and the bend radius.
• Anchors : where applicable, mechanical fixings can be used at dedicated points (if present on the model).

In sunderstood

• 2 modules sturdy, driveable and high visibility/strong>.
• Protects cables/pipes and reduces the risk of stumble And damage.
• Modular And quick to install, for indoor/outdoor use.

Note: Data and flow rates are indicative; always refer to the lot's technical data sheet and applicable construction site/local regulations.