Adhesive thermal acoustic insulation for roller shutter boxes

Adhesive thermal-acoustic insulation for roller shutter boxes — draft-proof & noise reduction

CE-marked, Made-in-Italy polyethylene panel with adhesive backing, engineered for roller shutter box insulation: it cuts heat loss, blocks draughts and dampens outdoor noise. Ideal for quick retrofits that boost comfort without masonry work.

Key benefits

• Stop draughts from the shutter box: less cold air in winter and less hot air in summer.
• Energy savings: mitigates thermal bridges around the window frame.
• Acoustic comfort: sound-reducing barrier that softens the most annoying outdoor noises.
• Fast install: self-adhesive, cut to size and apply in minutes.
• Vapour barrier and water-resistant to protect the cavity.
• Compatible with most shutter boxes (PVC, wood, aluminium) and shutters.

Where to use

• Roller shutter boxes in homes, offices and shops.
• Quick upgrades on existing buildings when the box is the weak point.
• Combine with brush seals/gaskets to maximise air-tightness.

Installation (step-by-step)

1. Open the box and check internal clearances (shutter travel, strap/motor).
2. Clean the base and inner walls: dry, dust- and grease-free.
3. Measure & cut with a utility knife and straightedge; dry-fit before peeling the liner.
4. Apply: peel gradually and press evenly from centre to edges.
5. Joints: butt without overlap; seal joints with aluminium/PE tape if needed.
6. Close and verify smooth shutter travel along the full stroke.

Pro tips

• Do not obstruct guides, straps or inspection points; keep the required clearance.
• On irregular cavities, work in modules: base → walls → trims.
• For best performance, check and replace worn brushes/labyrinth seals.

Compatibility & honest limits

• Designed for indoor use and dry cavities.
• Does not replace structural repair of damaged/leaky boxes: restore the substrate first.
• Thermal/acoustic performance and sizes/thicknesses: see the product page and official data sheet.

What’s in the box

Supplied as adhesive rolls/panels as specified on the product page (quantity, thickness and sizes depend on the selected option). Technical documentation available on request.

At a glance

• Shutter-box insulation made simple.
• Less draughts and less noise for instant comfort.
• Made in Italy, CE-marked, adhesive polyethylene support.

FAQ

Yes, it fits most PVC, wood and aluminium boxes. Always verify clearances and shutter travel.

Draught reduction is immediate; acoustic benefit depends on cavity condition and joint sealing.

No. The adhesive is integrated. Apply on clean, dry surfaces with even pressure.

Yes. Cut with a sharp knife/scissors using a rigid guide.

Note: dimensions, thicknesses, pack info and official performance are listed on the product page.