Also excellent for CAMPER windows
ABG Approved Film
With the film we will send you the cutter to shape it and the squeegee to apply it.
Also available in the store at 5% and 30%
On normal polycarbonate it CANNOT be applied
On degassed polycarbonate it CAN be applied
The Black Shade Series blocks up to 43% of the solar energy entering through the windows, providing a “cool” effect.
Car window tinting films solve summer problems related to heat buildup inside the vehicle. These films, in addition to UV protection, provide scratch resistance and safety for car windows.
Thanks to the absence of heavy metals, they do not interfere with cell phone, GPS, or satellite radio reception.
Eliminates glare while driving. Increases privacy.
Protects the car interior from ultraviolet rays.
In case of glass breakage, it holds the shards. In summer you will achieve significant energy savings.
15% VLT (Visible Light Transmission). The film allows only 15% of light to pass through. Approved.
Window tinting films reduce the temperature increase inside the car, creating a comfortable environment; by reflecting solar rays, they help the air conditioner optimize energy efficiency and fuel savings.
Protects seats, dashboard, and upholstery from sun rays, reducing glare while driving. In case of glass breakage due to stones or accidents, it holds the shards protecting passengers. Provides a sporty and customized effect.
Easy to install.
Thermoformable to optimally adhere to any surface. Excellent resistance to any weather condition.
Why darken?
FOR A CORRECT APPLICATION
Cut the required part from the roll to size.
The protective film is located on the inside of the roll.
To peel off the protective film, use masking tape, stick a piece on a corner to lift an edge (the protective film is transparent).
If the climate is particularly dry, static electricity will make the work difficult.
To solve the problem, always use masking tape to keep the film stretched on a flat surface (table). When removing the protective film, pay close attention so that the part to be applied to the glass does not fold onto itself. To eliminate static charges, spray with soapy water (dish detergent is ideal) as soon as possible (preferably with a spray bottle).
Wet the glass with the same water. It is better to use a generous amount of water.
At this point, carefully take the sheet and place it on the glass. It will adhere by itself.
Move it into position and use the squeegee to push out the water and eliminate the remaining bubbles.
By following the instructions, you will have no problems applying it.
Multiple units will be sold attached. If you need separate pieces, please let us know.
