Modular rubber cable ramp — pack of 2, load-bearing up to 8–16 t
Professional solution for protect cables and pipes on pedestrian and vehicular paths. Each module, in high density rubber with yellow non-slip lid, organizes and secures the passages in construction sites, events, warehouses, workshops, logistics areas and parking. The modular design with male/female joints allows you to create lines of the desired length. Sale in pack of 2 modules (not A4 size).
Key Benefits
- Driveability: reinforced structure with axle load capacity up to 8–16 tons (indicative value, depends on the ground, load distribution and correct installation).
- High security: lid to yellow/black contrast, non-slip surface, bevelled anti-trip profile.
- Multi-channel protection: multiple internal compartments to separate and protect power cables, signal cables or low pressure pipes.
- Modular: quickly connects to other modules via interlocking joints male/female to cover long stretches.
- Robust toheavy use : Resists impacts, compression, water, dirt, oils and light vehicle traffic.
- Inside/outside: suitable for exhibition halls, loading areas, construction site routes, events and car parks.
Typical applications
- Events and fairs: cable passages for stage, audio, lighting, video and power.
- Construction sites and workshops: protection of temporary power lines and low pressure pipes.
- Warehouses and logistics: safe crossings in areas where pallet trucks/forklifts transit.
- Retail and offices: orderly passages without obstacles in areas open to the public.
Installation
- Prepare the base: install on a flat, clean, and dry surface; avoid slopes and depressions.
- Open the lid And houses the cables into the channels without crushing them; close until they click.
- Connect the modules using the male/female joints for the desired length.
- Report: In high traffic areas, use cones/tape or road markings as required by local regulations.
Synthetic specifications
| Packaging |
2 modules straight cable glands (not A4 format) |
| Material |
Body in eraser lid with non-slip finish |
| Channels |
Multi-channel for multiple cables/pipes (maximum recommended diameter according to technical data sheet) |
| Flow rate |
Up to 8–16 t per axle (with correct installation and adequate base) |
| Color |
Black (base) + Yellow (lid) for high visibility |
| Environment of use |
Indoor / Outdoor — weather, water and oil resistant |
| Junctions |
Male/Female for linear extensions with other compatible modules |
| Maintenance |
Washable with water and neutral detergents; periodically inspect closures and channels |
Notes and safety
- Crossing speed: maintain low speeds (< 10 km/h) on driveways with cable ramps.
- Correct installation: avoid sharp curves, suspended edges, and uneven surfaces; align the modules well.
- Compatibility: Use intact cables; check the diameter suitable for the channels and the bend radius.
- Anchors: where applicable, mechanical fixings can be used at dedicated points (if present on the model).
In sunderstood
- 2 modules sturdy, driveable and high visibility.
- Protects cables/pipes and reduces the risk of stumble And damage.
- Modular And quick to install, for indoor/outdoor use.
Note: Data and flow rates are indicative; always refer to the lot's technical data sheet and applicable construction site/local regulations.
