This insulating rubber roll is extremely suitable for places where high voltage work is carried out. An insulating rubber surface prevents electric shocks up to 30,000 volts.
You can order this insulating mat by the meter in length so that you always have the quantity you need and avoid waste. Note: the length of a complete roll is 10 meters.
If you order more than 10 meters, you will receive one (or more) complete rolls plus the extra meters.
Anti-electric shock rubber by the roll ✓ Protection for workplaces where high voltage is present ✓ Suitable for use in electrical panels, transformers, etc. ✓ Insulates and absorbs electric shocks up to 30,000 volts ✓ Non-slip thanks to its raised ribbed pattern ✓ Durable ✓ Flexible ✓ High tensile strength
INSULATING MAT COMPLIES WITH VDE 0303 Part 2 DIN 53481 Breakdown voltage 30,000 volts
Presentation: smooth upper surface and fabric-impression underlayer. Marking: yellow continuous print on the underlayer along the entire length of the roll. Applications: for flooring and general protection in power plants, electrical transformer cabins, engine rooms, industrial premises where high voltages are present, etc.
Rubber insulating mat for electrical areas — fine-ribbed, non-slip surface
Professional rubber matting with dielectric properties and a fine-ribbed surface for extra grip. Designed to create safe zones around switchboards, transformers, generators and test benches, reducing electric shock risk and improving footing stability where operators work.
Why it matters (no fluff)
- Local protection: insulates the operator from ground in electrical work areas.
- Traction: ribbed texture enhances grip and control underfoot.
- Fast setup: cut with a sharp utility knife; lay loose or bond where needed.
- Modular coverage: order by the metre/roll to build walkways, pads and work islands.
- Easy care: cleans with mild detergents; built to withstand intensive use.
Where to use it
- Substations and electrical rooms, MV/LV switchgear rooms, transformer stations.
- Dry industrial areas: engine rooms, control rooms, test and inspection benches.
- Maintenance zones near transformers, generators, switches and panels.
- Critical environments: only as allowed by internal procedures and local regulations.
Installation (step-by-step)
- Prepare the base: flat, clean, dry floor; remove dust, oils and residues.
- Cutting: use a sharp knife and straightedge; trim edges to avoid curling.
- Laying: loose-lay for low traffic; in busy areas bond with a suitable rubber-to-mineral adhesive.
- Joints: butt-joint strips without overlap; align the rib pattern for a neat finish.
- Signage: add “High Voltage” pictograms and pedestrian guidance where required.
Use & maintenance
- Cleaning: mild detergents and soft cloth/brush; avoid strong solvents that can dull rubber.
- Periodic inspection: replace if deep cuts, burns, swelling or visible wear are present.
- Storage: keep rolled, dry, away from UV and heat sources.
Honest limits & compliance
- Electrical performance and lab tests are listed in the product specifications; always consult the data sheet before use.
- Does not replace PPE or mats certified for live-working; follow company safety procedures.
- Intended for dry environments; for wet/slippery areas add protection and verify suitability.
Formats & custom cutting
Available by the metre and in rolls to minimise waste. For larger areas we can provide custom cuts and accessories (edge tapes/ramps) to remove trip steps. Commercial details, sizes and colour are on the product page.
At a glance
- Local insulation around electrical equipment.
- Non-slip fine-rib for safer footing.
- Quick cut & lay, even on complex paths.
- Simple maintenance and long service life.
Note: standards, tests, use limits and electrical parameters are provided in the technical documentation.
