- Online only
- Variants: ID 10 mm × 1 m or ID 20 mm × 1 m (nominal internal diameter).
- Material: fiberglass braid with red silicone coating.
- Use: thermal and abrasion protection for cables and pipes in engine compartments, workshops, HVAC systems and welding applications.
- Installation: slide the sleeve over the pipe or cable; it is neither heat-shrinkable nor wraparound.
Fixing: secure the ends with cable ties or suitable tape (not included).
Sales unit: one continuous 1-metre length; multiple units are supplied uncut when possible.
Silicone (Fiberglass) Thermal Sleeving — 1 m
Protects cables and pipes from radiant heat, sparks, splashes and abrasion with a tubular fiberglass braid coated in red silicone.
Main benefits
- Thermal and abrasion protection: suitable for engine compartments, workshops, HVAC systems and welding applications.
- Flexible tubular construction: follows gentle bends and slides directly over the component.
- Two diameters: ID 10 mm or ID 20 mm.
- Continuous supply: each unit equals 1 metre; multiple units are supplied uncut when possible.
How to choose the size
The stated size is the nominal internal diameter (ID). Choose a diameter equal to or slightly larger than the outside diameter of the pipe or cable, allowing for any fittings.
Installation
- Measure the component and remove any sharp edges.
- Slide the sleeve on from the free end; it is neither heat-shrinkable nor wraparound.
- Secure the ends with suitable cable ties or tape, not included.
Technical specifications
| Material | Fiberglass braid with red silicone coating |
|---|---|
| Sizes | ID 10 mm × 1 m; ID 20 mm × 1 m |
| Construction | Tubular, non-heat-shrinkable |
Important notes
The product helps protect against radiant heat, sparks and splashes, but does not replace prescribed metal shielding or insulation. Avoid tight bends.
Package contents
1 × 1-metre silicone thermal sleeve in the selected size.
901906
8058951954813
