Also great for CAMPER windows
ABG APPROVED FILM
With the film we will send you the cutter to shape it and the squeegee to apply it.
Also available in store at 15% - 30% - 45%
On normal polycarbonate they CANNOT be applied
On degassed polycarbonate they CAN be applied
The Black Shade Series repels up to 43% of the solar energy that passes through the windows, providing a “cool” effect
Car Window Tinting Films solve summer problems related to heat buildup inside the car. These films, in addition to UV protection, also provide scratch resistance and safety for car windows.
Thanks to the absence of heavy metals, they do not interfere with the reception of mobile phones, GPS, and satellite radio.
Eliminates glare while driving. Increases privacy.
Protects the interior of the car from ultraviolet rays.
In case of glass breakage it holds the shards. In summer you will have significant energy savings.
5% VLT (Visible Light Transmission). The film allows 30% of light to pass through. Approved.
The tinted films reduce the temperature rise inside the car, creating a comfortable environment; in addition, by reflecting solar rays they help the air conditioner optimize energy efficiency and fuel savings.
Protects seats, dashboard and upholstery from sun rays while reducing glare while driving. In case of window breakage caused by stones or an accident, it retains glass shards protecting passengers. Gives a sporty and customized look.
Easy to install.
Heat-shrinkable to optimally adhere to any surface. Excellent resistance to any weather condition
WHY TINT?
FOR CORRECT APPLICATION
Cut the necessary part from the roll.
The protective film is on the inner side of the roll.
To remove the protective film, use masking tape, a small piece stuck to a corner to lift an edge (the protective film is transparent).
If the climate is particularly dry, static electricity will make the job difficult.
To solve the problem, always use masking tape to keep the film stretched on a surface (table). When removing the protective film, pay close attention to ensure that the part to be applied to the glass does not wrinkle. To eliminate static charges, wet with soapy water (dish detergent works well) as soon as possible (ideally using a spray bottle).
Wet the glass with the same water. It’s better to use plenty of water.
At this point, carefully take the sheet and place it on the glass. It will stick on its own.
Move it into position and use the squeegee to remove the water and eliminate any bubbles.
By following the instructions, you will have no problems with application.
Multiple units will be sold attached. If you need separate pieces, please let us know at
[email protected] or via chat.
