Also great for CAMPER windows
ABG Approved Film
With the film we will send you the cutter to shape it and the squeegee to apply it.
Also available in store at 5% and 15%
On normal polycarbonate they CANNOT be applied
On degassed polycarbonate they CAN be applied
The Black Shade Series repels up to 43% of solar energy passing through the windows, providing a “cool” effect
Car Window Tinting Films solve summer issues related to heat buildup inside the car. These films, in addition to UV protection, also provide scratch and safety protection for car windows.
Thanks to the absence of heavy metals they do not interfere with mobile phone, GPS, or satellite radio reception.
Eliminates glare while driving. Increases privacy.
Protects the car interior from ultraviolet rays.
In case of glass breakage it holds shards together. In summer you will have significant energy savings.
30% VLT (Visible Light Transmission). The film lets only 30% of light pass through. Approved.
The window tinting films reduce the temperature rise inside the car, creating a comfortable environment; in addition, by reflecting sunlight they help the air conditioner optimize energy efficiency and fuel savings.
Protects seats, dashboard, and upholstery from sun rays while reducing glare while driving. In case of glass breakage due to stones or accident, it holds shards together protecting passengers. Gives a sporty and customized effect.
Easy to install.
Thermoformable to optimally adhere to any surface. Excellent resistance to all weather conditions
Why tint?
FOR CORRECT APPLICATION
cut the necessary part from the roll to size.
The protective film is located on the inside of the roll.
To peel off the protective film, use masking tape, sticking a piece in a corner to lift an edge (the protective film is transparent).
If the climate is particularly dry, static electricity will make the job difficult.
To solve the problem, always use masking tape to keep the film stretched out on a surface (table). When removing the protective film, pay close attention so that the part to be applied to the glass does not fold over itself. To eliminate static charges, wet with soapy water (dish soap is ideal) as soon as possible (ideally use an empty spray container).
Wet the glass with the same water. It is better to use a generous amount of water.
At this point, carefully take the sheet and place it on the glass. It will adhere on its own.
Move it into place and use the squeegee to expel the water and eliminate remaining bubbles.
By following the instructions, you will have no problems with application.
Multiple units will be sold attached. If you need separate pieces, please let us know.
