Self-sealing aluminum pipe insulation tape — 50 mm × 10 m (antifreeze)

Self-Sealing Aluminum Pipe Insulation Tape — 50mm × 10m

Reduce leaks, condensation, and the risk of frost on pipes with this 50 mm × 10 m roll of insulation . The aluminum foil surface reflects radiant heat, and the foam underneath improves insulation: it rolls directly onto the pipe and seals itself without additional glue.

What is it for?

• External antifreeze for exposed pipes (water, heating, irrigation).
• Insulation of internal/technical sections to reduce leaks and condensation.
• HVAC : ducts and refrigerant lines, supply/return sections near boilers and heat pumps.

Why choose it

• Self-sealing : closes when overlapping, quick and clean installation.
• Reflective Aluminum : Helps against radiant heat and protects the foam.
• Flexible & cuttable : adaptable to curves and connections, can be finished with scissors.
• No dismantling : roll up and fix, the system remains operational.

How to apply (4 steps)

1. Clean the tube: dry, free from dust/grease.
2. Pre-measure the length and cut to the required length.
3. Wrap with 30–50% overlap while maintaining uniform traction.shapes.
4. Seal the ends; outdoors, protect exposed joints with suitable aluminum tape./li>

Technical specifications

Important notes

• Non-heat shrinkable and not suitable for direct contact with hot parts (exhausts, burners).
• Check local regulations on insulation and reaction to fire in technical environments.
• For maximum outdoor effectiveness, protect joints and reduce thermal bridges around supports.

Content

1 × Roll of Pipe Insulation Tapestrong>50 mm × 10 mstrong>.

FAQ

Do you need adhesive? No: the band isem>self-sealing and closes on itself. On the outside, you can reinforce the ends with aluminum tape.p>

Is it suitable for heating systems? Yes, it was created for hot/cold water and HVAC pipes as a wrap-around insulation band.

How much overlap? 30–50% depending on exposure and desired thickness.