Also excellent for CAMPER windows
ABG Approved Film
With the film we will send you the cutter to shape it and the squeegee to apply it.
Also available in the store at 50 cm height
The Black Shade Series blocks up to 43% of the solar energy passing through the windows, providing a “cool” effect.
Car Window Tint Films solve summer problems related to heat buildup inside the car. These films, in addition to UV protection, provide scratch resistance and safety for car windows.
Thanks to the absence of heavy metals, they do not interfere with cell phone, GPS, or satellite radio reception.
Eliminates glare while driving. Increases privacy.
Protects the car interior from ultraviolet rays.
In case of glass breakage, it holds the shards. In summer, you will achieve significant energy savings.
5% VLT to 45% VLT (Visible Light Transmission). The film lets only the indicated percentage of light through. Approved.
Window tinting films reduce temperature increase inside the car, creating a comfortable environment; by reflecting solar rays they help the air conditioner optimize energy efficiency and fuel savings.
Protects seats, dashboard, and upholstery from sunlight, reducing glare while driving. In case of glass breakage due to stones or accidents, it holds the shards protecting passengers. Gives a sporty and customized effect.
Easy to install.
Thermoformable to adhere optimally to any surface. Excellent resistance to all weather conditions.
Why darken?
FOR CORRECT APPLICATION
Cut the necessary piece from the roll.
The protective film is on the inside of the roll.
To peel off the protective film, use masking tape, stick a small piece on a corner to lift an edge (the protective film is transparent).
If the climate is particularly dry, static electricity will make the job difficult.
To solve the problem, always use masking tape to keep the film stretched on a surface (table). When removing the protective film, pay close attention so that the part to be applied to the glass does not fold onto itself. To eliminate static charges, spray soapy water (dish soap works well) as soon as possible (ideally using a spray bottle).
Wet the glass with the same water. It is better to use plenty of water.
At this point, carefully take the sheet and place it on the glass. It will stick on its own.
Move it into place and use the squeegee to push out the water and remove any remaining bubbles.
By following the instructions, you will have no problems applying it.
Multiple units will be sold attached. If you need separate pieces, please let us know.
